KE3700 xDSL Multitester

מאפיינים מרכזיים

The “All-in-one” Solution for all Broadband Technologies!

The KE3700 xDSL MultiTest is the ideal tool for service technicians of network operators and ICT specialists – for testing current and future broadband technologies. The new version 2 contains several improvements compared to its predecessor, including more powerful hardware and optimized edge protection.

לקבלת הצעת מחיר
  • ADSL-ADSL2+, VDSL2, VDSL2 (Vectoring / Super Vectoring), xDSL-Bonding and G.fast with autoservice detection
  • SHDSL support, 2 to 8 wire
  • SFP port for Digital Diagnostic Mode, optical level / power meter, Triple Play tests, GPON-ONT
  • Maximum throughput rates for performance measurements in gigabit networks
  • VoIP tests including SIP trunk and MultiCalling with extensive statistics
  • IPTV tests with IPTV scan and preview image as well as statistics
  • WLAN connectivity and triple play tests (data, VoIP, IPTV) with web browser
  • ISDN UK0 / S0 / S2M and Analogue Test Handset Function
  • Copper test (KECT), DC measurements, resistance fault localization (RFL), TDR measurements, KE905
  • remotely controllable line switch
  • High frequency measurements for cable qualification up to 31 MHz
Compliance ADSL1/2/2+ ITU-T G.992.5 (ADSL2+ incl. Annex A, B, J, M),
ITU-T G.992.3 (ADSL2 incl. Annex A, B, J, L),
ITU-T G.992.1 (G.DMT incl. Annex A, B, J)
ATIS/ANSI T1.413 Issue 2
IEEE 802.3ah (PTM)
ITU-T G.998.1/2 (Bonding)
Compliance VDSL2 ITU-T G.993.2 Annex A, B (Vectoring)
ITU-T G.998.1/2/3 (Bonding with Profile 30a)
Profiles: 8a/b/c/d, 12a/b, 17a, 30a and 35b (Annex Q) optional
Band Plan: 997, 998, US0
IEEE 802.3ah (PTM)
Compliance G.fast ITU-T G.9700 / 9701
DSL parameters Maximum attainable bit rates
Actual achieved bit rates
Actual bonded achieved rates
Latency modes: fast, interleaved
Data modes: ATM, PTM
Capacity (%)
Signal-to-noise ratio (SNR) margin
Output power
Attenuation
Bits/bin ttenuation/bin (Hlog/bin), QLN/bin, SNR/bin
Vendor code, revision
Interleave depth
Interleave delay
INP
G.INP
Vectoring
Modes: PTM, ATM
LOS, FEC, CRC, HEC, LOF, LOM, SES, ES
LATN per band, SATN per band
Test interfaces ADSL 1/2/2+ / VDSL2 / VDSL2-Vectoring / Super Vectoring / G.fast with autodetection
Ethernet 10/100/1000
Ethernet 10/100/1000 management
Webbrowser applicable for test interfaces
Encapsulation RFC 2684 supporting bridged Ethernet (IPoE), IPoA (RFC 1577), PPPoE (RFC 2516), PPPoA/LLC and PPPoA/VC-MUX (RFC 2364)
Operating modes DSL Terminal, Router and Modem Mode
Modem replacement (DSL to Ethernet)
Ethernet Terminal-Mode
Connectivity support TR69 / BNG
LAN/WAN status
DNS, gateway
DHCP client / server, DHCP vendor class
NAT VLAN ID, VLAN tagging
VPI/VCI
IPv4 and IPv6
Signal Strength
Ping test* Ping destination: Gateway, IP-Address or URL
Number of Pings: 1 to 9999
Packet size: 56 to 2048 Bytes (default is 56)
Timeout: 1 to 2000 seconds
Results: Packets sent/received, average round-trip delay (ms)
(* Run any number of tests simultaneously)
Trace Route test* Traceroute destination: Gateway, IP-Address or URL
Timeout: in seconds, maximum is 120 s
Packetsize: 32 Bytes
Number of hops: 1 to 100 (default is 30)
Results: Indicates IP address of hop and round trip time in milliseconds (ms)
(* Run any number of tests simultaneously)
FTP/HTTP speed tests* Address: IP or URL
Direction: Upload and/or Download up to 700 MBit/s
Results: Time, kB transferred, speed in kBit/s
Bookmarks: User-definable
(* Run any number of tests simultaneously)
Software options VoIP Test (terminal simulation): SIP protocol support, DSL and Ethernet; Codecs: G722, GSM, L16, A-Law, µ-Law, Speex; Results: MOS, R factor, Latency. Jitter, Packets (loss, sent)
IPTV Test (Set Top Box emulation): Video standards: MPEG2, MPEG4 part 2 and 10, DSL and Ethernet; Programmable channel list, analyzes up to 10 streams simultaneously; Results: MOS, R factor, Latency. Jitter, Packets (loss, sent)
Interface options xDSL bonding module
SHDSL 2-8 wire interface
KECT copper qualifying up to 31 MHz and Telco Multimeter
TDR fault detection / localization
SFP-Port for copper, fibre (second GbE-Port) or GPON, transceiver optional
ISDN BRI Uk0 / S0 / POTS interface
ISDN PRI S2m interface
Wi-Fi interface 2.4/5 GHz, 802.11b,g,n
Power supply LiPo battery with approximately 4 hours operation at full load mode
Dimensions 230 x 110/90 x 70 mm
Weight 1100 g
Housing Impact-resistant ABS case with protective and high impact plexiglass as display cover
Menu languages German, English, French, Italian, Dutch, Spanish